Vs standing up on a ladder half the day trying to leave the timer in place and set it where it was 9ft up on a wall out of the range of the mist heads. I’d never bought these 3controllers I’d found something else that was a smart device so I could set it using my phone from a air conditioned building then wifi the set programs to the device. All in all if I could do it all over again. I kept all 3 thinking I’m sure I’ll use them on other Applications. Bait a switch on a older timer that didn’t work by the seconds. I set a endless time a cycle that will run from 7am-6pm 3sec run at 10min intervals. A setting that only should work if you’re setting the time by the days of the week. I’m referring to start times underneath the days settings. And I’m talking about the actual clock timing settings. But if you don’t set it 1min ahead of the time you at currently at it will not keep time and the timer will not work. The dumbest thing ever! A setting that your not even suppose to mess with. As in the timer will stop keeping time and will not keep counting down. If u don’t set that time a min ahead before the actual time it is currently. The same setting that they’re telling u that has nothing to do with cycle timing, which is BS!! It does. What in the hell? After about a hr of swapping zones I noticed it was trying to water on zone 1? Haha wth? There’s a start setting. I went to zone 4! The last zone and it started working again. Then I set it for a more practical time session and for no reason at all it stops working again! So. After hours of nothing and out of the blue it starts working? Scared me when it went off lol. As a last ditch effort, I swapped to another zone and somehow using all the same settings it started to work. I spent over half the day messing with it trying to figure out what’s up with it. I did everything by the book and… nothing. I set this timer up on my propagation benches in my greenhouse.
0 Comments
Leave a Reply. |